Drying a structure correctly isn't about running a few fans and hoping — it's a calculated process based on temperature, humidity, and airflow readings.
Our Ward, AR drying plans start with thermal imaging to map exactly where moisture is hiding.
We calculate drying requirements using temperature and humidity data, not a flat per-room rule.
LGR capacity is standard equipment on every Structural Drying And Dehumidification job, not a premium upgrade.
We map hidden moisture with thermal imaging before finalizing equipment placement.
Moisture readings are logged daily throughout the Structural Drying And Dehumidification job so progress is measurable, not assumed.
Below is the calculated, documented process our Ward, AR teams follow.
The assessment sets the baseline every later reading gets measured against.
We map the full extent of moisture intrusion before placing a single air mover.
We position air movers to create directed airflow across wet surfaces based on the assessment.
Daily monitoring confirms equipment is working and adjusts the plan if progress stalls.
Hardwood floors and built-in cabinetry require slower, more controlled drying to avoid warping.
The job closes only once moisture readings match the documented dry standard for each material type.
Tell our Ward, AR dispatcher about the current condition so we can prepare the right diagnostic equipment.
Equipment for psychrometric assessment is standard on every drying dispatch.
A full diagnostic assessment comes before any equipment placement or pricing.
We verify final moisture readings against dry standard before removing equipment.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
A room can look dry on the surface while moisture meters still detect trapped moisture inside materials.
It's a calculated approach using temperature and humidity data to determine exact equipment needs, rather than guessing.
Timeline depends on material type and how much moisture the thermal scan revealed.
Daily documentation is standard, giving you real data rather than just an assurance.
Yes, we use slower, controlled drying specifically calibrated for hardwood to prevent warping.
We treat flat readings as a signal to recalculate, not something to wait out.
Ward is within our core structural drying response zone.
One call starts the psychrometric assessment process.
Call +1-844-833-1325